| 1. | Remove the center console. |
| 2. | Pull up the parking brake fully (8 to 10 clicks). |
| 3. | Start at the front edge (A), peel lever grip away from lever cap (B). Continue to peel the grip from the lever to gain access to the hooks (C).
|
| 4. | Push in both sides of the hook (A) on the lever cap (B), and remove the lever cap and the pushrod (C) with the knob (D).
|
| 5. | Remove the lever grip (A) by sliding it up.
|
| 6. | Remove the clip (A) on driver's side of parking brake lever cover (B).
|
| 7. | Separate the parking brake lever covers, and remove them. |
| 1. | Install the clip (A) on driver's side of the parking brake lever cover (B) to the lever (C).
|
| 2. | Install the passenger's side of the parking brake lever cover (D), and squeeze both sides of the cover together. |
| 3. | Install a new lever grip (A) by sliding it over the cover.
|
| 4. | Install a new lever cap (A) on to the lever by aligning the notch (B) in the cap with the tab (C) on the lever.
|
| 5. | With the lever cap and grip in position, push down on the cap to lock the hooks (D) into place. |
| 6. | Carefully peel back the front edge (A) of the lever grip, and apply a small amount of gel type superglue (B). Carefully push the grip back into place and wait a minute for the glue to adhere.
|
| 7. | Install a new pushrod (A) with the knob (B), and push them into the parking brake lever (C). NOTE: Do not use the removed push rod and knob.
|
| 8. | Release and pull the parking brake about 10 times. |
| 9. | Check the push knob play of about 2 mm (0.08 in.) and smoothly movement of the parking brake, then do the parking brake inspection. |
| 10. | Install the center console. |