Intermediate Shaft Reassembly

R16A1, R18A1 engine models

K20Z2 engine model

Special Tools Required
Driver ( 07749-0010000)

Attachment, 52 x 55 mm ( 07746-0010400)

Attachment, 35 mm I.D. ( 07746-0030400)

Oil seal driver ( 07GAD-PH70201)

NOTE:

Refer to the Exploded View as needed during this procedure.
These descriptions are R16A1 or R18A1 engine M/T models. The point of K20Z2 engine models that should be noted; the bearing support shape is different from the following. However, the procedure how to remove is the same.

1. Clean the disassembled parts with solvent, and dry them with compressed air. Do not wash the rubber parts with solvent.

2. Press the intermediate shaft bearing (A) into the bearing support (B) using the special tools and a press.

3. Seat the internal snap ring into the groove of the bearing support.

4. Press the intermediate shaft (A) into the shaft bearing (B) using the special tool and a press.

5. Seat the external snap ring (A) into the groove of the intermediate shaft (B).

6. Install the outer seal (A) into the bearing support (B) using the special tool and a press.

7. Install the set ring.