| 1. | Remove the steering gearbox. |
| 2. | Position the 34 mm socket wrench (A) on the flange part of the gearbox housing with a washer (B), 10 x 105 mm flange bolt (C) and the 10 mm nut (D) as shown.
|
| 3. | Hold the nut with a wrench, and tighten the flange bolt with another wrench. Remove the gearbox mount cushion (E). |
| 4. | Apply a mild soap and water solution to the new gearbox mount cushion surface (A), then place it on the gearbox mounting cushion hole.
|
| 5. | Push the mount cushion edge (B) for about 1/3 to the gearbox housing by using a flat-tipped screw driver. NOTE: Be careful not to damage the surface of the mount cushion when pushing it with the flat-tipped screw driver. |
| 6. | Position the 34 mm socket wrench on the flange part of the gearbox housing with a washer, flange bolt, and the nut as shown. |
| 7. | Install the gearbox mount cushion by tightening the nut until the mount cushion edges (A) properly fit on the gearbox flange surface.
|