| 1. | Remove the glove box. |
| 2. | Cut the plastic cross brace (A) in the glove box opening with diagonal cutters in the area shown, and discard it.
|
| 3. | Remove the bolts and the glove box frame (A).
|
| 4. | Remove the wire harness clip (A), the self-tapping screws, and the passenger's heater duct (B).
|
| 5. | Disconnect the connector (A) from the blower motor. Remove the wire harness clip (B).
|
| 6. | Disconnect the connector (A) from the recirculation control motor. Remove the self-tapping screws, the bolt, the mounting nuts, and the blower unit (B).
|
| 7. | Install the unit in the reverse order of removal. Make sure that there is no air leakage. |