| 1. | Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. |
| 2. | Disconnect the driver's airbag 4P connector, the front passenger's airbag 4P connector, both seat belt tensioner 4P connectors, and both seat belt outer lap tensioner 2P connectors. |
| 3. | Remove the front inner fender. |
| 4. | Disconnect the engine compartment wire harness 2P connector (A), and using a Torx T30 bit, remove the Torx bolt (B), then remove the front impact sensor (C). Discard them.
|
| 1. | Install the new front impact sensor with new Torx bolt (A), then connect the engine compartment wire harness 2P connector (B) to the front impact sensor (C).
|
| 2. | Reconnect the negative cable to the battery. |
| 3. | After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON (II): the SRS indicator should come on for about 6 seconds and then go off. |
| 4. | Reinstall all removed parts. |