| 1. | Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. |
| 2. | Disconnect both seat belt tensioner connectors and seat belt outer lap tensioner connectors. |
| 3. | Remove the center console. |
| 4. | Disconnect the connectors and remove the Torx bolts (A), then pull out the SRS unit.
|
| 1. | Install the new SRS unit (A) with Torx bolts (B), then connect the connectors (C) to the SRS unit; push them into position until they click. NOTE: Be sure the SRS unit is sitting squarely against it's bracket before torquing the Torx bolt.
|
| 2. | Reconnect both seat belt tensioner connectors and seat belt outer lap tensioner connectors. |
| 3. | Reconnect the negative cable to the battery. |
| 4. | After installing the SRS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off. |
| 5. | Reinstall all removed parts. |