Dashboard Vent Removal/Installation

Driver's Outer Vent

NOTE: Take care not to scratch the dashboard and related parts.

2. Remove the screws securing the driver's outer vent (A), then remove the driver's outer vent from the subdisplay visor (B).

3. Install the outer vent in the reverse order of removal.

Driver's Center Vent

NOTE: Take care not to scratch the dashboard and related parts.

1. Remove the audio unit:

1 CD type
6 CD type
1 DIN 1 CD type

2. Remove the screws securing the driver's center vent (A), then remove the driver's center vent from the center panel (B).

3. Install the center vent in the reverse order of removal.

Passenger's Vent

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.

NOTE:

Take care not to scratch the dashboard and related parts.
Put on gloves to protect your hands.
When removing components, use the handy remover set or equivalent.

1. RHD: Detach the hook (A) of the glove box damper (B).

2. While holding the glove box (A), release the glove box stop (B) on each side from the dashboard by pushing them inside.

3. Push on this side hooks (A) by hand to release them. Gently pull out the side vent (B) to release the other hooks (C), then remove the passenger's vent.

Outer
Center

4. Install the passenger's vents in the reverse order of removal.