Front Individual Map Light Test/Replacement

With sunroof

1.	Turn the map light switch OFF.

2.	Carefully pry the lens (A) off with a small screwdriver. Front Map Light:  8 W x 2

3.	Remove the screws, then remove the map lights (B) and sunroof switch (C).

4.	Disconnect the 3P connector from the map lights and the 10P connector from the sunroof switch.

5.	Check for continuity between the terminals in each switch position according to the table.

6.	If the continuity is not as specified, check the bulb(s). If the bulb(s) are OK, replace the light assembly.

7.	Install in the reverse order of removal.

Without sunroof

1.	Turn the map light switch OFF.

2.	Carefully pry the lens (A) off with a small screwdriver. Front Map Light:  8 W x 2

3.	Remove the screws, then remove the map lights (B).

4.	Disconnect the 3P connector (C) from the map lights.

5.	Check for continuity between the terminals in each switch position according to the table.

6.	If the continuity is not as specified, check the bulb(s). If the bulb(s) are OK, replace the light assembly.

7.	Install in the reverse order of removal.