| 1. | Turn the ignition switch ON (II). |
| 2. | Try to start the engine. Does the engine start? YES - The immobilizer system is OK, go to 3. NO - Go to the immobilizer symptom troubleshooting information.n |
| 3. | Turn the ignition switch OFF. |
| 4. | Connect the HDS to the data link connector. |
| 5. | Close all doors, then turn the ignition switch ON (II). |
| 6. | Enter the BODY ELECTRICAL menu, and check the door switch parameters. Do all door switches indicate OFF? YES - Go to 6. NO - Faulty door switch or shorted door switch wire. Repair a short in the wire or door switch.n |
| 7. | Remove the ignition key from the ignition switch. |
| 8. | Disconnect the immobilizer-keyless control unit 7P connector. |
| 9. | Check for voltage between the immobilizer-keyless control unit 7P connector No. 1 terminal and body ground.
Is there battery voltage? YES - Go to 10. NO - Check the No. 23 (10 A) fuse in the under-hood fuse/relay box. If the fuse is blown, replace the fuse and repair a short to ground in the wire. If the fuse is OK, repair an open in the wire.n |
| 10. | Disconnect the ignition key switch 6P connector. |
| 11. | At the ignition key switch side, check for continuity between the ignition key switch 6P connector No. 1 and No. 2 terminals.
Is there continuity? YES - Faulty ignition key switch or short to ground, replace the steering lock assembly.n NO - Go to 12. |
| 12. | Insert the ignition key into the ignition switch. |
| 13. | At the ignition key switch side, check for continuity between the ignition key switch 6P connector No. 1 and No. 2 terminals.
Is there continuity? YES - Go to 14. NO - Faulty ignition key switch, replace the steering lock assembly.n |
| 14. | Check for continuity between the immobilizer-keyless control unit 7P connector No. 6 terminal and the ignition key switch 6P connector No. 1 terminal.
Is there continuity? YES - Go to 15. NO - Repair an open in the wire.n |
| 15. | Check for continuity between the immobilizer-keyless control unit 7P connector No. 6 terminal and body ground.
Is there continuity? YES - Repair a short to ground in the wire.n NO - Replace the immobilizer-keyless control unit.n |