| DTC 86-01: | F-CAN Bus-off Malfunction |
| 1. | Turn the ignition switch ON (II). |
| 2. | Clear the DTC with the HDS. |
| 3. | Turn the ignition switch OFF, then turn it ON (II) again. |
| 4. | Check for DTCs with the HDS. Is DTC 86-01 indicated? YES - Go to 5. NO - Intermittent failure, the system is OK at this time. Check for loose terminals between the ECM/PCM connector A (44P), the gauge control module (tach) connector (36P) and the ABS modulator-control unit 25P connector. Refer to intermittent failures troubleshooting.n |
| 5. | Turn the ignition switch OFF. |
| 6. | Short the SCS line with the HDS. |
| 7. | Disconnect ECM/PCM connector A (44P). |
| 8. | Disconnect the ABS modulator-control unit 25P connector. |
| 9. | Check for continuity between the ABS modulator-control unit 25P connector terminal No. 1, No. 17 and body ground individually.
Is there continuity? YES - Repair the short to ground in the appropriate wire.n NO - Go to 10. |
| 10. | Check for continuity between ABS modulator-control unit 25P connector terminals No. 1 and No. 17.
Is there continuity? YES - Repair short in the wire between ABS modulator-control unit 25P connector terminals No. 1 (CAN-H line) and No. 17 (CAN-L line).n NO - Go to 11. |
| 11. | Check for continuity between ABS modulator-control unit 25P connector terminal and ECM/PCM connector A (44P) terminal (see table).
Is there continuity? YES - Check for loose terminals in the ABS modulator-control unit 25P connector. If necessary, substitute a known-good ABS modulator-control unit and retest: Except K20Z2 engine model, K20Z2 engine model.n NO - Repair open in the wire between the ECM/PCM and the ABS modulator-control unit.n | |||||||||||