| DTC B1036: | IG1 Line Input Error |
| 1. | Clear the DTCs with the HDS. |
| 2. | Turn the ignition switch OFF, and then back ON (II). |
| 3. | Wait for 6 seconds or more. |
| 4. | Check for DTCs with the HDS. Is DTC B1036 indicated? YES - Go to 5. NO - Intermittent failure, the system is OK at this time. Check for loose or poor connection at the gauge control module (tach) 36P connector, and at the under-dash fuse/relay box connector Q (16P). If the connections are good, check the battery condition and the charging system.n |
| 5. | Check for DTCs with the HDS. Is DTC B1008 indicated with DTC B1036? YES - Go to the indicated DTC troubleshooting.n NO - Go to 6. |
| 6. | Check for voltage between the gauge control module (tach) 36P connector No. 17 terminal and body ground.
Is there battery voltage? YES - Faulty MICU or an open in the under-dash fuse/relay box internal circuit. Substitute a known-good under-dash fuse/relay box and recheck.n NO - Check for No. 10 (7.5 A) in the under-dash fuse/relay box. If the fuse is OK, check for an open in the wire between the under-dash fuse/relay box and the gauge control module (tach), or repair a short in the wire between the under-dash fuse/relay box and the gauge control module (tach).n |