Special Tools Required
Attachment, 24 x 26 mm ( 07746-0010700)
| 1. | Remove the breather cap (A), detent bolt (B), washer (C), spring (D), and steel ball (E). Remove the detent bolt (F) and the lockout solenoid (G).
|
| 2. | Remove the special bolt (A) and spring washer (B).
|
| 3. | Remove the shift lever (C) and shift arm (D) from the shift arm cover (E). |
| 4. | Remove the oil seal (F). NOTE: When installing, turn the alloy surface of the thrust washer to the shift arm cover side. |
| 5. | Remove the spring pin (A) from the select lever (B). NOTE: Install the spring pin into the interlock with the groove of the spring pin at the angle shown.
|
| 6. | Remove the select lever from the shift arm cover (C), then remove the shift piece (D) and the interlock (E). |
| 7. | Remove the oil seal (F). |
| 8. | Install in the reverse order of removal. |
| 9. | Remove the dirt and oil from the sealing surface. Apply liquid gasket (P/N 08718-0002) to the sealing surface. NOTE: Do not install components if too much time has passed after applying the liquid gasket (for P/N 08718-0002, no more than 4 minutes, for all others, no more than 5 minutes). Instead, remove the old residue and reapply the liquid gasket. |
| 10. | Install the oil seal (A) using the special tools.
|