Special Tools Required
Housing puller ( 07HAC-PK40102)
| 1. | Remove the shift solenoid valve cover (A), dowel pins (B), gasket (C), and harness clamp bracket (D).
|
| 2. | Disconnect the connectors from the shift solenoid valves, and remove the solenoid harness connector (E). |
| 3. | Remove the transmission housing mounting bolts (F) (19). |
| 4. | Align the spring pin (A) on the selector control shaft (B) with the transmission housing groove (C) by turning the selector control shaft with the detent plate. NOTE: Do not squeeze the end of the selector control shaft tips together when turing the control shaft.
|
| 5. | Install the special tool over the mainshaft, then remove the transmission housing. NOTE: If the top arm of your housing puller is too short, replace it with housing puller arm, 205 mm 07SAC-P0Z0101. |
| 6. | Remove the countershaft reverse gear and needle bearing. |
| 7. | Remove the lock bolt securing the shift fork, then remove the shift fork with the reverse selector together. |
| 8. | Remove the mainshaft subassembly (A), countershaft subassembly (B), and secondary shaft subassembly (C) together. If the reverse selector hub is removed by hand, remove the 4th-5th gear and needle bearings, and remove the mainshaft subassembly, then the countershaft subassembly and secondary shaft subassembly together.
|
| 9. | Remove the differential assembly. |