| 1. | Remove the air cleaner housing and air intake duct. |
| 2. | Disconnect the transmission range switch harness connector (A).
|
| 3. | Check for continuity between terminals at the harness connector. There should be continuity between the terminals in the following table for each switch position. 7-position Transmission Range Switch Harness Connector 5-position Transmission Range Switch Harness Connector |
| 4. | Transmission range switch test has finished if the test results are OK. If there is no continuity between any terminals, go to 5. |
| 5. | Apply the parking brake, and block both rear wheels. Raise the front of the vehicle, and make sure it is securely supported. Or lift the vehicle up on a hoist. |
| 6. | Remove the transmission range switch cover.
|
| 7. | Disconnect the transmission range switch connector.
|
| 8. | Check for continuity between terminals at the switch connector. There should be continuity between the terminals in the following table for each switch position. 7-position Transmission Range Switch Connector 5-position Transmission Range Switch Connector |
| 9. | If the transmission range switch continuity check is OK, replace the faulty transmission range switch harness. |
| 10. | If there is no continuity between any terminals, remove the transmission range switch, and check the end of the selector control shaft (A).
| ||||||
| 11. | The measurement of the selector control shaft end is within the standard, replace the transmission range switch. If the measurement is out of the standard, repair the selector control shaft end, and recheck the transmission range switch continuity. |