DTC Troubleshooting: P0365 (89-2)

DTC P0365:  Camshaft Position (CMP) Sensor No signal


NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information.

1.Clear the DTC with the HDS.

2.Start the engine.

3.Check whether the DTC P0365 is indicated in the DTCs/Freeze Data in PGM FI Mode Menu with the HDS.

Is DTC P0365 indicated in the PGM FI system?


YES - Troubleshoot for DTC P0365 in the PGM-FI System.


NO - Go to 4.


4.Check whether the DTC P0365 is indicated in the DTCs/Freeze Data in A/T Mode Menu with the HDS.

Is DTC P0365 indicated?


YES - Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes away with a known-good PCM, replace the original  PCM.n


NO - Intermittent failure, the system is OK at this time.n