| 1. | Make sure you have the anti-theft code for the radio or the navigation system, then write down the customer's audio presets. |
| 2. | Disconnect the negative cable from the battery first, then disconnect the positive cable. |
| 3. | Remove the splash shield.
|
| 4. | Remove the intake manifold bracket.
|
| 5. | Remove the two bolts securing the starter, then remove the starter from the engine.
|
| 6. | Disconnect the starter cable (A) from the B terminal, then disconnect the BLK/WHT wire (B) from the S terminal.
|
| 7. | Remove the harness clamp (C), then remove the starter. |
| 1. | Install the starter cable (A) and BLK/WHT (B) wire. Make sure the starter cable crimped side of the ring terminal is facing out.
|
| 2. | Install the harness clamp (C). |
| 3. | Install the starter, and tighten the bolts.
|
| 4. | Install the intake manifold bracket.
|
| 5. | Install the splash shield.
|
| 6. | Connect the positive cable to the battery first, then connect the negative cable. |
| 7. | Start the engine to make sure the starter works properly. |
| 8. | Enter the anti-theft code for the radio or navigation system, then enter the customer's audio preset. |
| 9. | Set the clock. |
| 10. | Do the power window control unit reset procedure. |