Special Tools Required
Adjustable bearing puller, 20-40 mm ( 07JAC-PH80100)
| 1. | Remove the bearing set plate (A) from the clutch housing (B).
|
| 2. | Remove the needle bearing (A) using the special tool and a commercially available 3/8''-16 UNF slide hammer (B), then remove the oil guide plate C.
|
| 3. | Position the oil guide plate C and new needle bearing (A) in the bore of the clutch housing (B).
|
| 4. | Install the needle bearing using the special tool. |
| 5. | Install the bearing set plate (A) with bolts (B).
|