| DTC P0108: | MAP Sensor Circuit High Voltage |
| 1. | Turn the ignition switch ON (II). |
| 2. | Check the MAP SENSOR in the DATA LIST with the HDS. Is about 160 kPa (1,197 mmHg, 47.1 in.Hg), or 4.49 V or more indicated? YES - Go to 3. NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the MAP sensor and the ECM/PCM.n |
| 3. | Turn the ignition switch OFF. |
| 4. | Disconnect the MAP sensor 3P connector. |
| 5. | Connect MAP sensor 3P connector terminals No. 2 and No. 3 with a jumper wire.
|
| 6. | Turn the ignition switch ON (II). |
| 7. | Check the MAP SENSOR in the DATA LIST with the HDS. Is about 160 kPa (1,197 mmHg, 47.1 in.Hg), or 4.49 V or more indicated? YES - Go to 8. NO - Go to 18. |
| 8. | Remove the jumper wire from the MAP sensor 3P connector. |
| 9. | Measure voltage between MAP sensor 3P connector terminals No. 1 and No. 3.
Is there about 5 V? YES - Go to 14. NO - Go to 10. |
| 10. | Turn the ignition switch OFF. |
| 11. | Jump the SCS line with the HDS. |
| 12. | Disconnect ECM/PCM connector C (44P). |
| 13. | Check for continuity between ECM/PCM connector terminal C14 and MAP sensor 3P connector terminal No. 3.
Is there continuity? YES - Go to 25. NO - Repair open in the wire between the ECM/PCM (C14) and the MAP sensor, then go to 20. |
| 14. | Turn the ignition switch OFF. |
| 15. | Jump the SCS line with the HDS. |
| 16. | Disconnect ECM/PCM connector C (44P). |
| 17. | Check for continuity between ECM/PCM connector terminal C11 and MAP sensor 3P connector terminal No. 2.
Is there continuity? YES - Go to 25. NO - Repair open in the wire between the ECM/PCM (C11) and the MAP sensor, then go to 20. |
| 18. | Turn the ignition switch OFF. |
| 19. | Replace the MAP sensor. |
| 20. | Reconnect all connectors. |
| 21. | Turn the ignition switch ON (II). |
| 22. | Reset the ECM/PCM with the HDS. |
| 23. | Do the ECM/PCM idle learn procedure. |
| 24. | Check for Temporary DTCs or DTCs with the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P0108 is indicated, check for poor connections or loose terminals at the MAP sensor and the ECM/PCM, then go to 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting. NO - Troubleshooting is complete.n |
| 25. | Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM. |
| 26. | Check for Temporary DTCs or DTCs with the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P0108 is indicated, check for poor connections or loose terminals at the MAP sensor and the ECM/PCM, then go to 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting. NO - If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM.n |