| DTC P0341: | CMP Sensor and CKP Sensor Incorrect Phase Detected |
| 1. | Turn the ignition switch ON (II). |
| 2. | Clear the DTC with the HDS. |
| 3. | Test-drive at a steady speed between 30-60 km/h (19-38 mph) for 10 minutes. |
| 4. | Check for Temporary DTCs or DTCs with the HDS. Is DTC P0341 indicated? YES - Go to 9. NO - Go to 5. |
| 5. | Do the VTC TEST in the INSPECTION MENU with the HDS. Is the result OK? YES - Go to 6. NO - Go to 9. |
| 6. | Test-drive at a steady speed between 30-60 km/h (19-38 mph) for 10 minutes. |
| 7. | Check the VTC STATUS in the DATA LIST with the HDS. Does it indicate ON? YES - Go to 8. NO - Go to 6 and recheck. |
| 8. | Monitor the OBD STATUS for DTC P0341 in the DTCs MENU with the HDS. Does the screen indicate FAILED? YES - Go to 9. NO - If the screen indicates PASSED, intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM/PCM. If the screen indicates NOT COMPLETED, go to 6 and recheck. |
| 9. | Turn the ignition switch OFF. |
| 10. | Test the VTC oil control solenoid valve. Is the VTC oil control solenoid valve OK? YES - Go to 11. NO - Replace the VTC oil control solenoid valve, then go to 14. |
| 11. | Check the camshaft timing. Is the camshaft timing OK? YES - Go to 12. NO - Reset the camshaft timing, then go to 14. |
| 12. | Check for damage or stretch at the cam chain. Is the cam chain damaged? YES - Replace the cam chain, then go to 14. NO - Go to 13. |
| 13. | Inspect the VTC actuator. Is the actuator OK? YES - Go to 14. NO - Replace the VTC actuator, then go to 14. |
| 14. | Turn the ignition switch ON (II). |
| 15. | Reset the ECM/PCM with the HDS. |
| 16. | Clear the crank pattern with the HDS. |
| 17. | Do the ECM/PCM idle learn procedure. |
| 18. | Do the crank pattern learn procedure. |
| 19. | Test-drive at a steady speed between 30-60 km/h (19-38 mph) for 10 minutes. |
| 20. | Check for Temporary DTCs or DTCs with the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P0341 is indicated, check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM/PCM, then go to 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting. NO - Go to 21. |
| 21. | Monitor the OBD STATUS for DTC P0341 in the DTCs MENU with the HDS. Does the screen indicate PASSED? YES - Troubleshooting is complete.n NO - If the screen indicates FAILED, check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM/PCM, then go to 1. If the screen indicates NOT COMPLETED, go to 19 and recheck. |