| DTC P1157: | A/F Sensor (Sensor 1) Circuit Malfunction |
| 1. | Turn the ignition switch ON (II). |
| 2. | Clear the DTC with the HDS. |
| 3. | Start the engine, and wait 1 minute. |
| 4. | Check for Temporary DTCs or DTCs with the HDS. Is DTC P1157 indicated? YES - Go to 5. NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the ECM/PCM.n |
| 5. | Turn the ignition switch OFF. |
| 6. | Jump the SCS line with the HDS. |
| 7. | Disconnect the A/F sensor (Sensor 1) 4P connector. |
| 8. | Disconnect ECM/PCM connector C (44P). |
| 9. | Connect A/F sensor (Sensor 1) 4P connector terminals No. 1 and No. 2 with a jumper wire.
|
| 10. | Check for continuity between ECM/PCM connector terminals C29 and C30.
Is there continuity? YES - Go to 14. NO - Go to 11. |
| 11. | Remove the jumper wire from the A/F sensor (Sensor 1) 4P connector. |
| 12. | Connect A/F sensor (Sensor 1) 4P connector terminal No. 2 to body ground with a jumper wire.
|
| 13. | Check for continuity between ECM/PCM connector terminal C29 and body ground.
Is there continuity? YES - Repair open in the wire between the ECM/PCM (C30) and the A/F sensor (Sensor 1), then go to 15. NO - Repair open in the wire between the ECM/PCM (C30) and the A/F sensor (Sensor 1), then go to 15. |
| 14. | Replace the A/F sensor (Sensor 1). |
| 15. | Reconnect all connectors. |
| 16. | Turn the ignition switch ON (II). |
| 17. | Reset the ECM/PCM with the HDS. |
| 18. | Do the ECM/PCM idle learn procedure. |
| 19. | Check for Temporary DTCs or DTCs with the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P1157 is indicated, check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the ECM/PCM, then go to step 1. If the connector and terminal fits are OK, go to 22. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting. NO - Go to 20. |
| 20. | Monitor the OBD STATUS for DTC P1157 in the DTCs MENU with the HDS. Does the screen indicate PASSED? YES - Troubleshooting is complete.n NO - If the screen indicates FAILED, check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the ECM/PCM, then go to 1. If the screen indicates NOT COMPLETED, go to 18 and recheck. |
| 21. | Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM. |
| 22. | Check for Temporary DTCs or DTCs with the HDS. Are any Temporary DTCs or DTCs indicated? YES - If DTC P1157 is indicated, check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the ECM/PCM, then go to 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting. NO - If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM.n |