| 1. | Inspect the thrust needle bearing and the needle bearing for galling and rough movement.
|
| 2. | Inspect the splines for excessive wear and damage. |
| 3. | Check shaft bearing surface for scoring and excessive wear. |
| 4. | Before installing the O-rings, wrap the shaft splines with tape to prevent O-ring damage. |
| 5. | Lubricate all parts with ATF during assembly. |
| 6. | Install the conical spring washer, 41 x 68 mm thrust washer in the direction shown. |
| 7. | Replace the locknut and conical spring washer with new ones when assembling the transmission. |
| 8. | Check the clearance of the 5th gear. |