Special Tools Required
Clutch spring compressor set ( 07LAE-PX40000)
| 1. | Remove the snap ring with a screwdriver.
|
| 2. | Remove the clutch end-plate (A), clutch discs (B) (3), clutch waved-plates (C) (3), and waved spring (D) from the 5th clutch drum (E).
|
| 3. | Remove the clutch end-plate (A), clutch discs (B) (3), clutch waved-plates (C) (3), and waved spring (D) from the 4th clutch drum (E).
|
| 4. | Install the special tools.
|
| 5. | Be sure the special tool (A) is adjusted to have full contact with the return spring retainer (B).
|
| 6. | If either end of the special tool is set over an area of the spring retainer that is unsupported by the return spring, the retainer may be damaged.
|
| 7. | Compress the return spring until the snap ring can be removed.
|
| 8. | Remove the snap ring with the snap ring pliers.
|
| 9. | Remove the special tools. |
| 10. | Remove the snap ring (A), spring retainer (B), and return spring (C).
|
| 11. | Wrap a shop rag around the clutch drum, and apply air pressure to the fluid passage to remove the piston. Place a finger tip on the other passage while applying air pressure.
|
| 12. | Remove the clutch piston (A), and remove the outer O-ring (B) and inner O-ring (C) from the piston.
|