Special Tools Required
Clutch spring compressor set ( 07LAE-PX40000)
| 1. | Soak the clutch discs thoroughly in ATF for a minimum of 30 minutes. |
| 2. | Install the new O-rings (A) on the clutch piston (B).
|
| 3. | Install the clutch piston (A) in the clutch drum (B) while applying pressure and rotating to ensure proper seating. Do not pinch the O-ring.
|
| 4. | Install the return spring (A) and spring retainer (B), and position the snap ring (C) on the spring retainer.
|
| 5. | Install the special tools.
|
| 6. | Be sure the special tool (A) is adjusted to have full contact with the spring retainer (B).
|
| 7. | If either end of the special tool is set over an area of the spring retainer that is unsupported by the return spring, the retainer may be damaged.
|
| 8. | Compress the return spring until the snap ring can be installed.
|
| 9. | Install the snap ring with the snap ring pliers.
|
| 10. | Remove the special tools. |
| 11. | Install the waved spring (A) in the 5th clutch drum (B). Starting with the clutch waved-plate, alternately install the waved-plates (C) (3) and discs (D) (3). Install the clutch end-plate (E) with the flat side down on the top disc.
|
| 12. | Install the waved spring (A) in the 4th clutch drum (B). Starting with the clutch waved-plate, alternately install the waved-plates (C) (3) and discs (D) (3). Install the clutch end-plate (E) with the flat side down on the top disc.
|
| 13. | Install the snap ring with a screwdriver to secure the clutch end-plate.
|
| 14. | Check that the clutch piston moves by applying air pressure into fluid passage. |