A/T 1st, 2nd, and 3rd Clutch Disassembly

Special Tools Required
Clutch spring compressor set (  07LAE-PX40000)
 

Clutch spring compressor attachment (   07LAE-PX40100)
 
Clutch spring compressor attachment (   07HAE-PL50101)
 
Clutch spring compressor bolt assembly (   07GAE-PG40200)
 
Snap ring pliers (  07LGC-0010100)
 



1.Remove the snap ring with a screwdriver.

 

2.Remove the clutch end-plate (A), clutch discs (B) (4), clutch waved-plates (C) (4), and waved spring (D) from the 1st clutch drum (E).

 

3.Remove the clutch end-plate (A), clutch discs (B) (4), clutch waved-plates (C) (3), clutch flat-plate (D), and waved spring (E) from the 2nd clutch drum (F).

 

4.Make a reference mark on the clutch flat-plate (D).

5.Remove the clutch end-plate (A), clutch discs (B) (4), clutch waved-plates (C) (3), clutch flat-plate (D), and waved spring (E) from the 3rd clutch drum (F).

 

6.Make a reference mark on the clutch flat-plate (D).

7.1st, 2nd, 3rd clutch disassembly is completed. Do not remove the return spring retainer from the 1st, 2nd, 3rd clutch.

NOTE: The 1st, 2nd, 3rd clutch packs are included clutch pressure release pressure cavity between the spring retainer and clutch piston. The oil seal is installed on the circumference of the spring retainer, and contacts with the clutch piston. If you remove the spring retainer from the piston,it will damage to the oil seal when reinstalling the retainer in the piston.