A/T Regulator Valve Body Disassembly, Inspection, and Reassembly

1.	Clean all parts thoroughly in solvent or carburetor cleaner, and dry them with compressed air. Blow out all passages.

2.	Check all valves for free movement. If any fail to slide freely, refer to valve body repair.

3.	Hold the regulator spring cap in place while removing the stop bolt. The regulator spring cap is spring loaded.

4.	Coat all parts with ATF during assembly.

5.

When reassembling the valve body, align the hole in the regulator spring cap with the hole in the valve body, then press the spring cap into the valve body, and tighten the stop bolt.   SPRING SPECIFICATIONS Spring  Standard (New)-Unit: mm (in.)  Wire Diameter  O.D.  Free Length  No. of Coils  A  Stator reaction spring  4.5 (0.177)  35.4 (1.394)  30.3 (1.193)  1.92  B  Regulator valve spring A  1.9 (0.075)  14.7 (0.579)  80.6 (3.173)  16.1  C  Regulator valve spring B  1.6 (0.063)  9.2 (0.362)  44.0 (1.732)  12.5  D  Torque converter check valve spring  1.2 (0.047)  8.6 (0.339)  33.8 (1.331)  12.2  E  Lock-up shift valve spring  1.0 (0.039)  6.6 (0.260)  35.5 (1.398)  18.2  F  3rd accumulator spring  2.5 (0.098)  14.6 (0.575)  29.9 (1.177)    4.9  G  1st accumulator spring A  2.4 (0.094)  18.6 (0.732)  49.0 (1.929)    7.1  H  1st accumulator spring B  2.3 (0.091)  12.2 (0.480)  31.5 (1.240)    6.6