Wheel Sensor Replacement - With VSA

1.	Release the holding of clamps (A), then disconnect the wheel sensor connector (B).

2.	Remove the clips, the bolt, the O-ring (C) and the wheel sensor (D).

3.	Install the wheel sensor in the reverse order of removal, and note these items: Use a new O-ring on reassembly. Install the sensor carefully to avoid twisting the wires. If the wheel sensor comes in contact with the hub bearing, it is faulty.

4.	Start the engine, and check that the ABS and the VSA indicators go off.

5.	Test-drive the vehicle, and check that the ABS and the VSA indicators do not come on.