| 1. | If equipped with a side airbag, disconnect the negative cable from the battery, and wait at lease 3 minutes before beginning work. |
| 2. | Tilt the steering wheel all the way up, and telescope it all the way in. |
| 3. | Without front seat belt outer lap tensioner: Slide the front seat forward fully, and remove the anchor cover (A).
|
| 4. | Without front seat belt outer lap tensioner: Remove the lower anchor bolt (A).
|
| 5. | Remove the seat track outer end covers (A) and seat track center end covers (B) from the back of both seat tracks.
|
| 6. | Remove the bolts.
|
| 7. | Slide the front seat rearward fully, and remove the bolts.
|
| 8. | Lift up the front seat, then detach the harness clips (A), and disconnect the side airbag connector (B)(for some models), seat heater connector (C) (for some models), and the seat belt switch connector (D). Disconnect the OPDS subharness connector (E) or seat belt reminder switch connector (F) on the passenger's seat. LHD is shown; RHD is symmetrical. Passenger's seat with OPDS Passenger's seat without OPDS Driver's seat |
| 9. | With the help of an assistant, carefully remove the front seat through the front door opening. |
| 10. | Install the seat in the reverse order of removal, and note these items:
|