| DTC 27-11: | Steering Angle Sensor DIAG Signal Error (Initial) |
| 1. | Turn the ignition switch ON (II). |
| 2. | Clear the DTC with the HDS. |
| 3. | Turn the ignition switch OFF, then turn it ON (II) again. |
| 4. | Check for DTCs with the HDS. Is DTC 27-11, or 27-26 indicated? YES - Go to 5. NO - Intermittent failure, the system is OK at this time. Check for loose terminals between the steering angle sensor 5P connector and the VSA modulator-control unit 37P connector. Refer to intermittent failures troubleshooting.n |
| 5. | Turn the ignition switch OFF. |
| 6. | Disconnect the steering angle sensor 5P connector. |
| 7. | Disconnect the VSA modulator-control unit 37P connector. |
| 8. | Check for continuity between steering angle sensor 5P connector terminal No. 3 and body ground.
Is there continuity? YES - Repair short in the wire between the steering angle sensor and the VSA modulator-control unit.n NO - Go to 9. |
| 9. | Check for continuity between the VSA modulator-control unit 37P connector terminal and the steering angle sensor 5P connector terminal individually.
Is there continuity? YES - Go to 10. NO - Repair open in the wire between the steering angle sensor and the VSA modulator-control unit.n | ||||||||||||||
| 10. | Turn the ignition switch ON (II). |
| 11. | Measure voltage between steering angle sensor 5P connector terminal No. 3 and body ground.
Is there 0.1 V or more? YES - Repair short to power in the wire between the steering angle sensor and the VSA modulator-control unit.n |