| DTC 66-11: | Pressure Sensor (Inside of VSA Modulator-control Unit) Malfunction |
| DTC 66-13: | Pressure Sensor (Inside of VSA Modulator-control Unit) Malfunction |
| DTC 66-16: | Pressure Sensor (Inside of VSA Modulator-control Unit) Malfunction |
| 1. | Turn the ignition switch ON (II). |
| 2. | Clear the DTC with the HDS. |
| 3. | Turn the ignition switch OFF, then turn it ON (II) again. |
| 4. | Check for DTCs with the HDS. Is DTC 66-11, 66-12, 66-13, 66-14, or 66-16 indicated? YES - Check for loose terminals in the VSA modulator-control unit 37P connector. If necessary, substitute a known-good VSA modulator-control unit and retest.n NO - Intermittent failure, the system is OK at this time. Check for loose terminals at the VSA modulator-control unit 37P connector. Refer to intermittent failures troubleshooting.n |