| 1. | Make sure you have the anti-theft code for the audio. |
| 2. | Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
|
| 3. | Remove the battery. |
| 4. | Remove the cover (A).
|
| 5. | Remove the bolts (A), then remove the ECM/PCM (B).
|
| 6. | Disconnect the ECM/PCM connectors A (C), B (D), and C (E). NOTE: ECM/PCM connectors A, B, and C have symbols (A=¨, B=[utri], C=¡) embossed on them for identification. |
| 7. | Install the ECM/PCM and battery in the reverse order of removal. |
| 8. | KE, KG, TR models: Turn the ignition switch ON (II). NOTE: DTC P0630 ‘‘VIN Not Programmed or Mismatch'' may be stored because VIN has not been programmed into the ECM/PCM; ignore it, and continue this procedure. |
| 9. | KE, KG, TR models: Input the VIN to the ECM/PCM with the HDS. |
| 10. | Rewrite the immobilizer code with the ECM/PCM replacement procedure in the HDS; it allows you to start the engine. |
| 11. | Reset the ECM/PCM with the HDS. |
| 12. | Do the ECM/PCM idle learn procedure. |
| 13. | Do the crank pattern learn procedure. |
| 14. | Enter the anti-theft code for the audio and set the clock. |