| 1. | Loosen the upper torque rod mounting bolt (A).
|
| 2. | Remove the air cleaner housing assembly. |
| 3. | Remove the engine control module (ECM)/ powertrain control module (PCM) cover, then remove the three bolts securing the ECM/PCM. |
| 4. | Remove the ECM/PCM bracket. |
| 5. | Remove the under hood fuse/relay box from the bracket. |
| 6. | Support the transmission with a jack and wood block under the transmission. |
| 7. | Remove the transmission mount stiffener (A) (A/T). Remove the transmission mount (B). M/T A/T |
| 8. | Install the transmission mount with the new mounting bolts (C). Install the transmission mount stiffener (A/T). |
| 9. | Loosely tighten the new bolt and nuts (D). |
| 10. | Raise the hoist to full height. |
| 11. | Remove the splash shield. |
| 12. | Loosen the lower torque rod mounting bolt (A).
|
| 13. | Loosen the front mount mounting bolt (A) (M/T).
|
| 14. | Lower the vehicle on the hoist. |
| 15. | Tighten the transmission mounting bolt and nuts. M/T A/T |
| 16. | Raise the hoist to full height. |
| 17. | Tighten the lower torque rod mounting bolt.
|
| 18. | Lower the vehicle on the hoist. |
| 19. | Tighten the upper torque rod mounting bolt.
|
| 20. | Install the under-hood fuse/relay box to the bracket. |
| 21. | Install the ECM/PCM bracket. |
| 22. | Install the ECM/PCM, then install the ECM/PCM cover. |
| 23. | Install the air cleaner housing assembly. |
| 24. | Raise the hoist to full height, and tighten the front mount mounting bolt (M/T).
|
| 25. | Install the splash shield. |