A/T End Cover Park Lever Stop Inspection and Adjustment

1.	Set the park lever in the P position.

2.	Measure the distance (A) between the park pawl shaft (B) and the park lever roller pin (C). Standard:  57.7-58.7 mm (2.27-2.31 in.)

3.

If the measurement is out of standard, select and install the appropriate park lever stop (A) from the table.   PARK LEVER STOP Mark  Part Number  B  C  1  24537-PA9-003  11.00 mm (0.433 in.)  11.00 mm (0.433 in.)  2  24538-PA9-003  10.80 mm (0.425 in.)  10.65 mm (0.419 in.)  3  24539-PA9-003  10.60 mm (0.417 in.)  10.30 mm (0.406 in.)

4.	After replacing the park lever stop, make sure the distance is within tolerance.