| 1. | Remove the driver's door panel. |
| 2. | Disconnect the 10P connector (A) from the actuator (B).
|
| 3. | Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
|
| 4. | If the actuator does not operate as specified, replace it. |
| 1. | Remove the door panel, front passenger's, left rear door. |
| 2. | Disconnect the 10P connector (A) from the actuator (B). NOTE: The illustration shows the front passenger's door.
|
| 3. | Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
|
| 4. | If the actuator does not operate as specified, replace it. |
| 1. | Remove the right rear door panel. |
| 2. | Disconnect the 10P connector (A) from the actuator (B).
|
| 3. | Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
|
| 4. | If the actuator does not operate as specified, replace it. |