| DTC 25-9x (25-90 to 25-99, 25-9A to 25-9F): | Short to Ground in Left Side Seat Belt Outer Lap Tensioner |
Special Tools Required
SRS inflator simulator ( 07SAZ-TB4011A)
| 1. | Erase the DTC memory. |
| 2. | Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off. Does the SRS indicator stay on, and is DTC 25-9x indicated? YES - Go to 3. NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC Troubleshooting Index for troubleshooting details. |
| 3. | Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes. |
| 4. | Disconnect the floor wire harness 2P connector (A) from the left side seat belt outer lap tensioner.
|
| 5. | Connect the SRS inflator simulator (2 W connector) and simulator lead M to the floor wire harness. |
| 6. | Reconnect the negative cable to the battery. |
| 7. | Erase the DTC memory. |
| 8. | Read the DTC. Is DTC 25-9x indicated? YES - Go to 9. NO - Short to ground in the left side seat belt outer lap tensioner; replace the left side seat belt.n |
| 9. | Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes. |
| 10. | Disconnect the both seat belt tensioner 4P connectors. |
| 11. | Disconnect SRS unit connector B (28P) from the SRS unit. |
| 12. | Disconnect the SRS inflator simulator from the SRS simulator lead. |
| 13. | Check resistance between each terminal of the SRS simulator lead and body ground. There should be an open circuit or at least 1 MW.
Is the resistance as specified? YES - Faulty SRS unit; replace the SRS unit.n NO - Short to ground in the floor wire harness; replace the floor wire harness.n |