Crankshaft Pulley Removal and Installation

Special Tools Required
Handle (  07JAB-001020B)
 

Crankshaft pulley holder (  070AB-RJA0100)
 
Socket wrench, 19 mm (  07JAA-001020A)
 



Removal


1.Remove the front wheels.

2.Remove the splash shield.

3.Remove the drive belt.

4.Hold the pulley with holder handle (A) and holder attachment (B).

 

5.Remove the bolt with a 19 mm socket (C) and breaker bar, then remove the crankshaft.

Installation


1.Clean the crankshaft pulley (A), crankshaft (B), bolt (C), and washer (D). Lubricate as shown.

¡: Clean 
l: Lubricate 

 

2.Install the crankshaft pulley, and hold the pulley with holder handle (A) and holder attachment (B).

 

3.Tighten the bolt to 49 N·m (5.0 kgf·m, 36 lbf·ft) with a torque wrench and 19 mm socket (C). Do not use an impact wrench.

4.Tighten the pulley bolt an additional 90 °.

5.Install the drive belt.

6.Install the splash shield.

7.Install the front wheels.